Your FPGA Design Partner

 

 

amontec

 

 

               icn_cart   View Basket   | Checkout   | Tracking order |  Logout

Block Diagram

master_small02 visa_small
BUY ONLINE

We ship our products worldwide!
Please check our online
Shipping Cost Calculator


Amontec JTAGkey related links

Amontec JTAGkey
Undedicated USB to JTAG cable
Based on FTDI FT2232
Amontec JTAG Pinout
Including Official ARM 20-pin Connector ( JTAG Pin-out )
Amontec JTAG Accelerator
Now fully supported by OpenOCD JTAG software.
Amontec sdk4arm
Software Dev. Kit for ARM
Eclipse - GCC - OpenOCD - JTAGkey - your arm target board


Amontec Chameleon Links

Amontec Chameleon POD The generic JTAG interface Dongle
Amontec ARM Debug ValuePack
The easiest way for ARM JTAG and other ARM debug
Amontec JTAG Accelerator
The solution to flash ARM via JTAG at 363Kbytes/sec.
Amontec Chameleon Programmer Configure your POD in the minute with pre-compiled configurations.

corner_nav_br

The Generic USB to JTAG interface cable :
Amontec JTAGkey jtagkey_small02
 > Home > Products > Chameleon POD > Block Diagram

Chameleon POD Block Diagram
chameleon_blockdiagram

Most important Components

 A Coolrunner CPLD (programmable logic, LVTTL 3.3V and 5V tolerant I/O pins)
 A 32MHz Crystal Oscillator
 A DSUB 25-pin male connector (computer side)
 A DSUB 25-pin female Connector (for user side and for power supply source)
 A power Jack Connector
 A Slide Switch allowing the mode selection ('configure' mode or 'use' mode)
 A red LED for custom uses
 A yellow LED for configuration mode signalization
 A green LED for power signalization
 A DC-DC Linear Regulator allowing the Chameleon board to be used in different power level environments.

 

Contact   Amontec Team today ...
spacer02
[Home] [Policy & Privacy] [Sitemap]

Copyright © 2003-2008, Amontec - Gauch. All rights reserved.